HeatShield Products HP Sticky Shield

SKU: HSPSticky
$52.61 to $351.28
(0) No Reviews yet

Details

  • Capable of reflecting over 90% of radiant heat

  • Flexible, bends and conforms to almost any shape

  • Perfect for nearly all race car applications

  • Adhesive backing sticks to almost any clean surface

  • Can be cleaned after installed

  • Made in the USA


HP Sticky Shield™ is the ultimate way to stop heat from radiating into the driver’s compartment of your race car. Made from a dense layer of 1/8-inch-thick fiberglass insulation and shielded by a rugged layer of 0.003" thick aluminum, HP Sticky Shield™ may be cleaned after installation and is resistant to the elements.

The heavy-duty peel-and stick adhesive will bond to almost any clean surface, although it is not recommended for unfinished fiberglass or carbon fiber. It is the perfect radiant heatshield for transmission tunnels, mufflers, catalytic converters, DPFs, turbos, downpipes and exhaust systems.

HP Sticky Shield™ can be used with less than 1 inch of airspace. However, when used with 1 inch or more of airspace, this peel and stick heat shield is capable of shielding over 90 percent of heat. 

HP Sticky Shield™ is asbestos-free and designed to be used under the vehicle on the floorpan, firewall, transmission tunnel and more. This sticky heat shield is not designed to be used underneath carpet. Use the included HP Armor Tape™ to seal seams when putting two of these heatshields together, and also to protect the edges of HP Sticky Shield™. You can even use the tape to repair any damage caused to HP Sticky Shield™ from on- or off-road hazards.

Ratings & Reviews

No reviews available

Be the first to Write a Review